So you've found the laminate that you are watching the model, design, color and price come together and your now ready to begin your home improvement project. The project will be long, but the end result will be worth it. If your goal is to improve the aesthetics of your home or the home value by improving your kitchen, the project will increase leaving you with a sense of fulfillment.

The first step is to prepare the surface for cards.

Remove the old ceiling surface
Sand
Clean surface
Use of the course on the surface of the sand paper in preparation for cement contact
Apply all rolled back if necessary, reduce the moisture content is in the work plan

Note *

The removal of adhesives, paints and enamel key is looking for professional results.

The second step is to prepare the tables.

Measure the area ofdetermine the size and shape.
We recommend the use of a knife or a fine-tooth cutting backsaw to the floor. (You can also use a circular saw, jigsaw or saber saw.)

a. Allow yourself room for error to ensure a few inches to match the laminate, you can cut the leaves later to ensure you get the right fit.

b. The technology for cutting the sheets is cut to the design of this site and with a low angle.

The third step is the creation, the surface and laminateLeaf placement.

Experts recommend the use of cement on the bond markets, contact your laminate surface. (Epoxy adhesives also works as a binder.)

With a brush, a layer of cement in contact with the surface that you want to apply the laminate.
Apply a smooth layer of contact cement on the back of the panels.
Read the instructions on the contact cement to dry so dry for the recommended time.

a. Take care to admit, not that the cement dryWhile this may reduce the adhesion.

b. A good rule is only that if the contact feels dry to the touch, it is probably ready.
Note *
Do you need an additional chip contact cement mantle to trim the edges of the ceiling.

The fourth phase is the positioning of the axes on the surface.

This must be done carefully. The adhesive force of the contact between the cement and 50-70% at first contact. Thus, the positioning of the tabsperfect, before contact is a must. You can do this by strips of wood, dowel rods or wrapping paper.

Place strips of wood or dowel rod to fit a foot addition, if a larger sheet laminate. Or, place brown paper on the surface. (This step is not needed when placing panels on the vertical surface.)
Tables made on the surface, if the placement is perfect and then remove the strips of wood, dowel rod, or wrapping paper.
Use a rollerthroughout the area, make sure the plastic laminate is sealed to the surface, this will also help remove any air pockets. For this task, you can also use a wooden block or mallet, you should start from the center and with the help of these tools.
If you make a seam route on the larger sheet laminate sheet smaller. Slice through the leaves to the point that they are removing overlap, then rolled in excess.

The fifth stageAnd the placement of the panels at the edges.

Measure and cut edges of tables accordingly. Remember, leaves cut off with a few inches more to ensure that the area you can customize later cut, and leaves.
Two layers of concrete on the surface of the edge of contact.
A layer of contact cement on the strip of plastic laminate.
Let the contact cement to dry for the time recommended on the instructions of the product.
Carefully placed tablesLining up the perfect arch at the head of the edge of the counter.

Go slowly and press firmly to make sure that the sheet is sealed to the surface at all points.

The sixth and last step post-processing and cleaning the work surface again.

Let the contact cement to dry completely.
Off any excess laminate to the edges using a router with a special knife to remove the laminate, you can use a file if the gap is small. Be careful and go slowly when cutting the laminate in excess, a slightMiscalculation could break the floorboards.
Clean excess contact cement with a special solvent, if you have the solvent can also polish to remove it.

Thanks To : Cheap Hats 50 inch LCD TV